All Science Fair Projects  

Science Project Forum

Welcome to the Mad Scientist's Forum! Join thousands of other students who've received help from the Mad Scientist and our science Mentors!
Register first, then post your questions below. Registration takes only 1 minute! Meet the Mad Scientist
Lost your
Go Back   All Science Fair Projects > Get Help for Your Grade 9-12 Science Fair Projects > Chemistry (Grades 9-12)
User Name

Thread Tools Display Modes
Old 10-12-2008, 01:33 AM
worth scientist's Avatar
worth scientist worth scientist is offline
Junior Member
Join Date: Oct 2008
Location: India
Posts: 3
Rep Power: 0
worth scientist is helpful, nice and has lots of friends here
Question help mee

how to make a simple hydrogen fuel cell project
Reply With Quote
Old 11-21-2008, 01:52 PM
colleen_13's Avatar
colleen_13 colleen_13 is offline
Senior Member
Expert Contributor
Join Date: Nov 2008
Location: Madrid
Posts: 54
Rep Power: 12
colleen_13 is helpful, nice and has lots of friends here
Send a message via AIM to colleen_13
Default Here's how:....

To make the fuel cell, we need the following:

One foot of platinum coated nickel wire, or pure platinum wire. Since this is not a common household item, we carry platinum coated nickel wire in our catalog.
A popsicle stick or similar small piece of wood or plastic.
A 9 volt battery clip.
A 9 volt battery.
Some transparent sticky tape.
A glass of water.
A volt meter.

The first step is to cut the platinum coated wire into two six inch long pieces, and wind each piece into a little coiled spring that will be the electrodes in our fuel cell. I wound mine on the end of the test lead of my volt meter, but a nail, an ice pick, or a coat hanger will do nicely as a coil form.
Next, we cut the leads of the battery clip in half and strip the insulation off of the cut ends. Then we twist the bare battery lead wires onto the ends of the platinum coated electrodes, as shown in the photo. The battery clip will be attached to the electrodes, and two wires will also be attached to the electrodes, and will later be used to connect to the volt meter.

The electrodes are then taped securely to the popsicle stick. Last, the popsicle stick is taped securely to the glass of water, so that the electrodes dangle in the water for nearly their entire length. The twisted wire connections must stay out of the water, so only the platinum coated electrodes are in the water.

Now connect the red wire to the positive terminal of the volt meter, and the black wire to the negative (or "common") terminal of the volt meter. The volt meter should read 0 volts at this point, although a tiny amount of voltage may show up, such as 0.01 volts.

our fuel cell is now complete.

To operate the fuel cell, we need to cause bubbles of hydrogen to cling to one electrode, and bubbles of oxygen to cling to the other. There is a very simple way to do this.

We touch the 9 volt battery to the battery clip (we don't need to actually clip it on, since it will only be needed for a second or two).

Touching the battery to the clip causes the water at the electrodes to split into hydrogen and oxygen, a process called electrolysis. You can see the bubbles form at the electrodes while the battery is attached.

Now we remove the battery. If we were not using platinum coated wire, we would expect to see the volt meter read zero volts again, since there is no battery connected.

However, platinum acts as a catalyst, something that makes it easier for the hydrogen and oxygen to recombine.

The electrolysis reaction reverses. Instead of putting electricity into the cell to split the water, hydrogen and oxygen combine to make water again, and produce electricity.

We initially get a little over two volts from the fuel cell. As the bubbles pop, dissolve in the water, or get used up by the reaction, the voltage drops, quickly at first, then more slowly.

After a minute or so, the voltage declines much more slowly, as most of the decline is now due only to the gasses being used up in the reaction that produces the electricity.

Notice that we are storing the energy from the 9 volt battery as hydrogen and oxygen bubbles.

We could instead bubble hydrogen and oxygen from some other source over the electrodes, and still get electricity. Or we could produce hydrogen and oxygen during the day from solar power, and store the gasses, then use them in the fuel cell at night. We could also store the gasses in high pressure tanks in an electric car, and generate the electricity the car needs from a fuel cell.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump

All times are GMT -8. The time now is 07:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Copyright (C) 2006 All Science Fair All Rights Reserved